Bright and simple seems to be the model illustration of most modern bathroom renovations, of course, starting from the overall design of the bathroom design. To improve the overall cleanliness, it is not necessary to start with the popularization of the public, pay attention to the matters that need special attention during the decoration process, prevent problems before they happen, and creative design can be played at will!
First, the ceiling design
The water vapor in the bathroom is heavier, so it is important to choose materials that are waterproof, anti-corrosive and rust-proof.
Second, the ground points
Before the floor tiles are paved, be sure to waterproof them. After the tiles are laid, ensure that the brick surface has a water discharge slope (usually about 1%), and the slope is facing the floor drain. The ground must be closed after the tiles are laid. At least 24 hours must be guaranteed; when laying the floor tiles, pay attention to the seams and alignment with the wall tiles to ensure the overall sense of the whole bathroom, so as not to create a visually confusing impression.
Third, strict waterproof road reconstruction
It is best not to make too much changes in the water supply and drainage lines of the bathroom. If it is to be changed, it should be determined according to the specific conditions. If the model of the washing machine is different, the position of the water and the water will be different, so the waterway does not move best.
Fourth, put the installation of good sanitary ware
It is best to remember the distance between the water holes before the decoration, and select the sanitary wares such as bathtubs, bath rooms, toilets, wash basins, etc. according to the size, so as not to be unsuitable in the decoration; it is best to use a good quality toilet, not to replace it. Very troublesome, please have a few hundred masters! (COTTO is strongly recommended) The toilet should be installed with a toilet mud and fixed with expansion screws or glass glue, so that it is easy to repair when the toilet is blocked. space.
Fifth, emphasize ventilation and ventilation
There must be an exhaust fan in the bathroom, and the exhaust fan must have a retrograde gate to prevent backflow of dirty air, non-gas backflow, etc.
Sixth, reserve greening embellishment
To add a little anger, the bathroom should not be a corner forgotten by the green. In this way, during the decoration, some pots that are resistant to yin, wet, and damp can be placed in the bathroom, which makes the bathroom even more angry.
Seven, wall considerations
The wall tiles in the bathroom should be protected from moisture and water, and the tiles should be flat when they are tiled. They should be seamed and aligned with the floor tiles to ensure the overall feeling of the wall and the ground; To be small and appropriate, it is convenient to cover the incision with the flange cover on the water supply device, so that the appearance is perfect and natural.
Eight, doors and windows should pay attention to
It is best to have windows in the bathroom for ventilation. If there are no windows to prevent ventilation, pay special attention to the details of the door. In order to prevent the water from overflowing in the bathroom, the door boundary should be slightly higher than the inner side of the bathroom; the gap between the door and the floor of the bathroom should be kept larger to facilitate the return air; if it is a sliding door, it must be in the sliding door. Make a layer of waterproof between the bathroom tiles to prevent water seepage.
Nine, pay attention to the laying of circuits
The wire joints in the bathroom must be hung with tin, and should be wrapped with waterproof tape and insulating tape to ensure safety; the wire body must be covered with flame retardant pipe; all switches and sockets must have moisture-proof boxes, and the location must also be based on electrical appliances. Size and location depend on the convenience of use, so as to reduce the trouble.
Concerned about surprises
Label: bathroom decoration precautions waterproof and electricity safety first
Previous: The most water-saving installation skill basin faucet to be installed like this Next: Paint selection must be wary of buying better than selling
Tool chests are equipped with heavy duty ball bearing slides and you can put them on roller cabinets.
Side Tool Cabinet,Rolling Tool Chest,Heavy Duty Tool Box,Tool Storage Chests
Changzhou Xingsheng Tianhe Electric Appliance Co., Ltd , https://www.roller-tool-cabinet.com