Although the floor heating market is continuously expanding, we will also prefer to use geothermal heating as the primary heating device when selecting heating equipment. However, heating such as floor heating is still a new thing after all, and some related facilities may not have suitable facilities. This has caused our doubts about the floor heating. We have not only stayed on the geothermal equipment. The choice of floor, the laying of floor heating and the price are all issues that we need to consider.
Isaiki warm
What floor to use for warmth
For the cold winter months, many families use floor heating to warm up. Floor heating brings new performance requirements to the floor. Because there are many types of flooring on the market, many consumers feel very upset and do not know what kind of floor is more suitable for us. According to senior experts, the following three aspects of performance should be paid attention to. The dimensional stability is better, the amount of formaldehyde released cannot exceed the standard, and the heat transfer is faster. These three properties are achieved. The floor you choose can basically make you comfortable in this winter.
How to choose to warm the floor
The choice of floor heating should be based on the special characteristics of geothermal heating methods: adapting to repeated changes in heat and cold and conducive to heat conduction. Geothermal floor to a small amount of deformation; to facilitate heat conduction; moisture-proof and waterproof.
Under the same environmental conditions, the solid wood floor is more deformed than the reinforced floor, and the reinforced floor has more layers of solid wood flooring. The reason for the small amount of deformation of the geothermal multi-layered solid wood floor (referred to as a geothermal floor) is its substrate, each horizontal and vertical staggered and intertwined; the back also has a dense deformation-resistant groove, which decomposes the stress generated by the heated surface. , so its deformation is minimal.
The thermal conductivity of the floor is related to the thickness of the floor. The thickness of the floor is similar to the thickness of the floor. However, the anti-deformation groove on the back of the floor is conducive to air circulation, reduce noise, and has better thermal conductivity than laminate flooring.
Indoor drying in winter, in general, humidification, moisture resistance of the floor is equally important. Geothermal floor after special treatment, the sample soaked in water for 3-5 days, there will be no obvious deformation; even if the ground running after a lot of water, soaking the arch, just open the doors and windows to maintain air circulation, will soon be restored to the original state.
Warm prices
Generally speaking, it is calculated by the square. Different brands and products have different prices. However, selected products should be selected for high cost performance products.
Electric heating 150-450 yuan / square meters of water to warm 70-230 yuan / square meter.
The difference in installation costs is mainly due to the product, installation quality and post-maintenance. Three-point product and seven-point installation must choose a regular company. The cost of later use depends on how warm your house is. The better the insulation of the house, the less heat loss, the lower the cost of use, you can consult the relevant website.
Is it warm to install?
The benefits of warmth are many, and there are many benefits to installing floor heating.
1, comfortable and healthy
The heat is radiated to the room, so that the indoor surface temperature is uniform, the indoor temperature gradually decreases from the bottom up, bid farewell to the heat of the first cold feet, the temperature difference of 10 degrees Celsius heating time. The heat is concentrated near the legs of the ground and it feels comfortable and meets the physiological requirements of the human body and is beneficial to health. Geothermal heating
2, clean and sanitary
Reduce contaminated air and clean air without pollution.
3. Expand the effective use of the room
Warm floor heating does not allow heating and piping to be seen in the entire room, and it does not need to be used for decoration or improper location of the radiator, which effectively increases the area of ​​use of the house.
4, long service life
The service life of the cross-linked polyethylene pipes used is up to 50 years and is equivalent to that of buildings. In the construction, the whole pipe is laid, there is no interface under the surface, no leakage, safe and reliable.
5, reduce floor noise
The added insulation has very good sound insulation.
6, effective energy conservation
The heat radiates from the bottom up, so that the heat is effectively concentrated in the human activity area and the heat loss is small. In a radiant heating environment, the actual temperature of the human body is about 2-3 degrees Celsius higher than the actual temperature, which saves energy and reduces the operating costs of the heating system.
7, automatic operation
According to the required temperature can be properly adjusted.
8, good thermal stability
Because of the backfill of concrete on the ground, the heat storage is large and the thermal stability is good. In the case of intermittent heating, the indoor temperature changes slowly.
Followed by the development of benefits: building upgrades, management, lightening, maintenance costs, low operating costs and long life and other advantages.
How to do if the floor is not warm
Many users of floor heating are faced with many problems. Among them, the geothermal heating effect is not ideal. The causes and solutions are as follows:
Problem 1: The other users in the same community have good heating results, and their own results are not good. When the geothermal heat is applied, the circuit is uneven. Solution: Use a small valve on the water separator to adjust the circulation of each circuit so that they can all be recycled. Achieve ideal heating effect.
Question 2: The main bar of geothermal heat. The backwater bar is not hot, and there is gas in the pipe, which causes hot water to enter the circuit and cannot be circulated. Solution: Use a gas release valve on the water separator to open the gas in the pipe and let it deflate until it is released. Hot water.
Question 3: The main bar of the water supply is not hot, and it may be that the quality of the hot water supply is too dirty, causing the filter to become clogged. It cannot be normally cycled. Open the filter with a live spanner, clean the filter inside, and reinstall it from the new installation. You can also find professional personnel to clean.
Question 4: Some business households have too high floor or district heating, and the pipeline pressure is not enough, resulting in unsatisfactory heating. In this case, it is necessary to find a heating company or find a property to solve. If this cannot be solved, it is recommended to install a circulating pump to improve Hot water circulation to achieve the desired heating effect. Geothermal pumps recommend the use of well-known foreign brands such as Ville in Germany and CAB in Italy. General geothermal pipelines can be cleaned once every 3 to 5 years.
Building Materials Knowledge Nature Flooring Del Floor Heating Heating Door Price House Room
The blade of a cutter knife is very sharp, and there are several parallel scribe lines on its blade. Because it is usually used to cut wallpaper, it is also called a "wallpaper cutter". Cutter knife is usually used in the decoration and advertising plaque industry. The biggest feature of the cutter knife is that it can be easy to replace the segmented blades. You can fold off the unsharp section of blade when using it, so the sharpness can be maintained without sharpening the blade frequently.
Cutter knife,Utility knife,plotter knife
Behappy Crafts (suzhou)Co.,Ltd , https://www.craftsbehappy.com