In the home decoration, the decoration of the bathroom is the most important and complicated part of the whole decoration. The place where the bathroom is often used for water, if there is no work at the time of decoration, it will be easy to have problems in the future. In addition, bathroom wall decoration is a place that people can easily ignore. Today, let the decoration of the home to explain the steps of the bathroom wall decoration and some precautions during the decoration.
Steps for bathroom wall decoration:
1. Selection and soaking of tiles
Before tiling, whether it is white or other color tiles, the specifications and colors must be selected. Because of the addition of p is the same quality tile produced by the same manufacturer. In the quality, color, specifications - l is also somewhat different. Use a slightly better tile for the visible wall and feed the slightly poor tile to the dark corner. Before affixing, the selected tiles should be soaked in clear water and dried before use.
2, the treatment of the wall
The wall treatment mentioned here is mainly for the new residential bathroom with tiles. Due to the health, the wall below 1.2m is the cement wall surface, and the 1.2m or more is the paper reinforced gray wall. For the treatment of the bathroom wall surface, a layer of cement mortar with 3 minutes of cement can be applied. Since the cement wall below 1.2m protrudes from the paper reinforced gray wall surface of 1.2m or more, it should be smeared at 1.2m in thickness and 1.2m thick to make the whole wall face vertical and flat. After 2 days, you can start tiling.
3, wet wall
Clean the treated wall surface, remove the residual glue and burrs on the wall and the corners, and then sprinkle with water to wet it, or use a wool brush to rub the wall to wet the wall.
4, the preparation of bonding mortar
The mortar is made of cement and the ratio of 107 glue to 102l, and then scraped on the back of the tile to prepare for pasting.
5, tiling
At the junction of the wall and the ground, place the tile coated with the bonding mortar on the wall, tap the brick surface with a wooden spatula to fill the mortar, and use a wooden ruler to flatten the tile. It must be noted that the first layer of tile is affixed and the horizontal ruler is only flat. Inlay tiles, mostly from the Yangdian, so that not a whole piece is used in the corner. Tiles need to be lined up when they are attached to the top layer. Each layer of tile seams is horizontal and vertical, and the unevenness should be leveled at any time. The most layer of tiled moss does not need to be pressed, and can be finished with a rounded tile.
6, rub the brick surface
After the scene tile is finished, before the final setting of the bonding mortar, the ash flowing out of the tile joint is wiped clean with waste paper, sawdust, cotton yarn or sponge, etc., to prevent the mortar from being hardened after hardening.
7, caulking
In order to be neat and tidy, the seam between the tile and the tile needs to be embedded with cement slurry. White ceramic tiles, usually with white cement paste caulking colored tiles, generally with cavities of colored cement.
Note on bathroom wall decoration:
The wall of the bathroom also needs to pay attention to a waterproof problem, especially in the bathing area, the wall around it needs to be painted to 1.8m when applying waterproof coating. In addition, the wall can also be paved with some wall tiles that match the style of the room to make a waterproof measure. The smooth and smooth wall tiles are also convenient for the user to clean and clean.
When the bathroom is renovated, it must be waterproof. In addition, the socket should be reserved when the wall is made. Try to minimize the number of eyes on the wall to prevent future moisture. If you want to know more about decoration, please stay tuned to the home of the decoration.
Cyclorama Light,Cyclorama Wash Effect Light,Led Cyclorama Wash Effect Light,Cyclorama Led Lighting
EV LIGHT Guangzhou Co., Ltd , https://www.evlightpro.com