Processing the fuel pipe tee, in order to ensure that the taper surface T and the screw hole M12×1.25 (Fig. 1) are turned into one clamping, we designed a special positioning fixture for rotary positioning, which is processed and used with good effect. The clip 8 (Fig. 2) is mounted on the CM6125 lathe spindle and tensioned with a tie rod. When machining, the workpiece is placed in the V-shaped seat 5, and the workpiece is pressed by the pressing screw 3. After the hole is machined, the gear shaft 1 is rotated to make the positioning tooth
Non-Locking Mast ,Antenna Push Up Pole,40 Ft Telescoping Pole,Portable Telescopic Mast
TIANHEMAST , https://www.robomasts.com